CODAR
OCEAN SENSORS
Enclosure 36
CODAR Product Code: ENC36
Product
Description: The SeaSonde Enclosure 36 is
a small, rugged closed-loop temperature-controlled
enclosure for containing
the SeaSonde remote unit electronics.
The small enclosure is just large
enough to fit the SeaSonde transmit
and receiver chassis, the mini-style
computer with small monitor (or
laptop
style computer), a UPS device
and another small piece of electronics.
This enclosure is appropriate
for both indoor and outdoor use.
Enclosure Features:
Powder-coated, dual-access, floormount
enclosure. Front and rear doors,
turn latches on doors,
padlockable (lock not incl.),
grounding struts, 19” rack-mount
rails, cable exit plate, thick
foam core insulation, internal
temperature
control via two closed-loop 1500
BTU/HR thermoelectric
solid state air conditioners,
condensate drip pans & rain
shroud. Ships
assembled (except rain shrouds),
ready to use
Includes: Enclosure with two
air conditioners and condensate
drip pans, stainless steel rain
shrouds with stainless steel
mounting
bracket (shrouds and brackets
not attached during shipment),
heat
sink shroud and fasteners for
air conditioners, power cord,
and 12
month warranty.
Recommended Accessory:
CODAR Product Code UPS1500, Uninterruptable
Power Supply (UPS)
|


CODAR Product Code: ENC36† |
Technical
Specifications†
|
Enclosure construction
NEMA 4X indoor/outdoor use
Welded Type 304 Stainless steel construction
3/4” thick foam core insulation
laminated poly/aluminum facers
Enclosure Dimensions
Dimensions: 36”h x 24”w x 32”d
Weight: approx. 365 lbs.
Access Doors
Two Front and rear doors, each fully gasketed, hinged left, latched right
Door Latches
Standard 1/4 turn latches, top right latch per door“ barrel style” and
padlockable (padlock not included)
Grounding Studs
Grounding studs (4) on doors and inside enclosure
Rack Rails
Side flange style with punched (not tapped) holes, for use with “clip-nuts” (included)
approx. 32” high and horizontally-adjustable (front-torear) on uni-strut
Cable Exit Plate
Type 304 stainless steel
Dimensions: 5.5”h x 13.5”w
Gasket covering 2”h x 12”w cable exit cut-out, plate
Mounting Tabs
4 built into enclosure (two on right, two n left)
|
Air Conditioners -
2 included
Thermoelectric solid state built-in adjustable thermostat Stainless steel
covers
Stainless steel mounting flange (20-1/4”h
x 13”w)
Neoprene mounting gaskets
Stainless steel mounting fasteners
Certification to UL/CSA standards
Condensation Treatment
One condensate drip pan per cooler.
Drip pan fittings and length of flexible
PVC drain tubing plumbed with enclosure small drain holes on right and left
sides of enclosure (towards bottom)
Air conditioner Requirement:
1500 BTU/HR rating (each)
NEMA 4X configuration
220 VAC (4.6 amps) (or, specify 110V instead of 220V at time of ordering)
Air conditioner dimensions
Through-mount design, will protrude 3-5/8” into enclosure
12-month limited mfr. warranty |
|
|
†Specifications and appearance are given as guidelines
and may change without notice.
SeaSonde Information & Specifications - version 1 created
12/2008
|